2003 Sarena Bay™
Export Owner’s Manual
Change Water
Change Vision Cartridge
Every four months the top line of your Digital Display Window will read
“CHANGE WATER” and the message “TURN POWER OFF, DRAIN &
REFILL SPA...PUSH AND HOLD ICON BUTTON MORE THAN 3 SECONDS TO RESET THIS MESSAGE” will scroll from right to left on the bottom line of the display.
To reset this message, push and hold the Dimension One Spas ICON (logo)→ Button located at the right hand side of the control for 3 seconds.
When “CHANGE VISION CARTRIDGE” is displayed on the Digital Display Window, the system is telling you that it is time to replace it.
To reset this message, push and hold the Dimension One Spas ICON (logo)→ Button located at the right hand side of the control for 3 seconds.
If you purchased a Vision cartridge subsequent to the initial start up of your hot tub, please follow the programming instructions for VISION as outlined in the next Vision Cartridge section to set the
Note
Spa Check Up | When “SPA CHECK UP” is displayed on the Digital Display Window, we |
| recommend that you have your hot tub inspected by your dealer as a |
| preventative maintenance measure. |
| To reset this message, push and hold the Dimension One Spas |
| ICON (logo)→ Button located at the right hand side of the |
| control for 3 seconds. |
| The system can dismiss and reset the maintenance messages by pushing and holding the | |
| Dimension One Spas ICON (logo)→, on the right end of the control, for 3 seconds. If you | |
| press the Dimension One Spas ICON (logo)→ for 5 seconds when there is no maintenance | |
Note | message, it will put the spa in the “Standby” mode. | |
|
| |
Overheat |
| DO NOT ENTER THE WATER when “OVERHEAT” is displayed on |
|
| the control system Digital Display Window because the hot tub is in a high |
|
| temperature condition. If such a condition exists, check the water |
|
| temperature with a certified thermometer and if it is above 40° C (≅104° F), |
|
| remove the hot tub cover and allow the water to cool. If the problem recurs, |
|
| turn off all power to the hot tub and contact your local Authorized |
|
| Dimension One Spas Dealer, or authorized service center. |
|
|
|
|
| The overheat condition could be caused by excessive filtration. |
|
| See the Troubleshooting Guide section for more information. |
|
| Note |
26
