Heat Status Light
Dimension One Spas ICON (Logo)→
2003 Sarena Bay™
Export Owner’s Manual
The Heat Status Light will turn on when there is a call for heat and the heater engages. This is a normal function. The right side of the Digital Display Window will continue to read the current temperature while the bottom left corner will scroll the message “HEATING TO _ _ _° C” until the hot tub reaches the set temperature. An animated thermometer will also be displayed in the upper center of the Digital Display Window to confirm heater activity.
If the water reaches 1° C (≅2° F) above the set temperature, the message
“COOLING TO _ _ _ - CIRC PUMP & O3 OFF” will be displayed in the bottom left hand side of the Digital Display Window and a cooling cycle will start.
The time of day can be viewed by pushing the Dimension One Spas ICON→- logo on the far right of the control panel. If no other button is pushed within 5 seconds, the display will revert to the hot tub water temperature reading. The
Pressing the logo for 5 seconds will place the spa in the “Standby” mode and allow the spa to be cleaned without turning off the power.
Scrolling Message Center Messages
Because of the advanced programming features of your scrolling Digital Display Window, your hot tub will prompt you when you need to perform routine maintenance. For example:
Rinse Filters
Clean Filters
Every other month, the top line of your Digital Display Window will read,
“RINSE FILTERS” and the message “REMOVE FILTERS & RINSE WITH
HOSE... PUSH AND HOLD ICON BUTTON MORE THAN 3 SECONDS TO RESET THIS MESSAGE” will scroll from right to left on the bottom line of the display.
To reset this message, push and hold the Dimension One Spas ICON (logo)→ located at the right hand side of the control for 3 seconds.
On alternating months, the top line of your Digital Display Window will read, “DIRTY FILTER” and the message “REMOVE FILTERS & CLEAN IN
SOLUTION... PUSH AND HOLD ICON BUTTON MORE THAN 3 SECONDS TO RESET THIS MESSAGE” will scroll from right to left on the bottom line of the display.
To reset this message, push and hold the Dimension One Spas ICON (logo)→ Button located at the right hand side of the control for 3 seconds.
25
