Dish Network 3.2, 3.0, 3.1 warranty Troubleshooting, What’s What’s Wrong What You Can Do Happening

TROUBLESHOOTING

What’s	What’s Wrong	What You Can Do
Happening
While you do	• If you don’t press	Start over again.
a remote	any button
procedure, the	for 20 seconds in
remote control	a programming
“times out.”	sequence,
	the remote
	“times out.”
	• If you hold a
	button longer
	than two
	minutes, the
	remote control
	stops
	transmitting to
	save battery life.
When you	• Maybe the	• Replace the remote batteries with
press the	batteries are	fresh ones.
remote control	weak or dead.
Power button
to turn the	• Maybe you didn’t	• Make sure the receiver power cord
receiver on,
	plug the receiver	is plugged into a power outlet.
the receiver’s
	power cord into a
front panel
	power outlet, or
Power light
	maybe there’s a
doesn’t turn
	problem with the
on.
	power.
		• Press SAT to set the remote to
	• Maybe the
	remote isn’t in	SAT mode to control the receiver.
	SAT mode.
	• Maybe the	• Make sure the remote and the
	remote and the	receiver have the same address.
	receiver have	See Setting Up to Control the
	different	Receiver on page 5.
	addresses.
The receiver	• UHF signals from	• Change your remote and receiver
changes	a neighbor's	address (see Setting Up to Control
channels and	remote may be	the Receiver on page 5).
displays	controlling your
menus when I	receiver.
am not using
the remote
control.

34