1.For DISH 322 receivers only: If you are using a 4.0 Remote control with the green 1 UHF Pro key installed, perform the steps a. through e. below. If not, then go to step 2.
a.Open the TV1 UHF Pro Setup screen by pressing
b.Select Enable from the TV1 UHF Pro Setup screen.
c.Press the SYS INFO button to open the System Information screen.
d.Move the highlight to the address for the Primary Remote Address as shown below. This is important - if you do not do this, your remote will change the receiver's Secondary Remote Address and cause your Remote Control 1 to control the 
side of your receiver.
Note: Highlight the Primary
Remote Address if you are using a 4.0 remote with a green 1 UHF Pro key.
Do not do this step if you are using 4.0 Remote with blue 2 key. This will cause your Remote Control 2 to control 
side of your receiver.
e.Go to step 3 below.
2.Open the System Information screen. Consult your receiver user's guide for instructions on how to open this screen without using the remote control. The System Information screen will show either one Remote Address, or it may show a
Primary Remote Address and a Secondary Remote Address.
Note: On the DISH 322, leave Done highlighted.
3.Press and hold the SAT mode button about three seconds, until all the mode buttons light up,
and then let go of the SAT button. The SAT mode button will blink.
4.Use the number buttons to enter any number
from 1 to 16. The SAT mode button goes out after you enter each digit, and then lights up again.
Write down the number you entered:
6
