SAFETY

IMPORTANT SAFETY INSTRUCTIONS (continued)

Do not place naked flame sources such as lighted candles on or near the receiver.

Do not expose the remote control batteries to excessive heat or fire.

Note to Installer: This reminder is provided to call the installer's attention to Article 810 section II of the National Electrical Code (NEC) that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

Example of Antenna Grounding

National Electrical Code, 2008

Antenna

Lead in Wire

Ground Clamp

Antenna

Discharge

Unit

(NEC Section 810-20)

Electric

Service

EquipmentGrounding

Conductors

(NEC Section 810-21)

Ground Clamp

Power Service Grounding

Electrode System

(NEC Art. 250, Part H)

Do not locate the antenna near overhead light or power circuits, or where it can fall into such power lines or circuits. When installing the antenna, take extreme care to avoid touching such power lines or circuits, as contact with them can be fatal.

iv

Page 6
Image 6
Dish Network 922 SlingLoaded, 176779 manual Important Safety Instructions, Example of Antenna Grounding