Dish Network DVR-7000 manual System Setup Menu, LNB1

EchoStar International Corporation	All rights reserved
© 2002

Familiarization Section 4

2.2.1. SYSTEM SETUP MENU

This sub menu allows you to customize the system setup to match your installation. Note that
the menu page is dynamic which means that it changes with the selections you make. You
can customize:
■	System
	To set the dish type you use.
■	LNBs
	To set the amount of LNBs you have installed.
■	Polarity
	To set the device that controls the signal polarity.
■	Switch
	To set the switch type which you use to control the
	dish installation (if used).
■	LNB1
	To set the LNB type(s) you use.
■	Method (motorized only)
	To set the scan method;
	AutoSat (automatically calculate the satellite
	positions from reference positions)
	Manual (enter the satellites by manual search).
■ AutoSat (motorized, AutoSat only)		4
	To confirm the selections you made and advance
	to the AutoSat setup page (AutoSat only)
■ Set Limits (motorized, manual only)
	To confirm the selections you made and advance
	to the Set Limits page.
■	Satellite (fixed only)
	To set the satellite you want to scan for the LNB.

■ Check Signal (fixed only)

To confirm the selections you made and advance to the Check Signal page.

■ LNB Power (SMATV only)

To select the distribution type (cable=Off, IF=On). ■ Symbol Rate 1-4 (SMATV only)

To set the symbol rate you want to scan. ■ Search Channels (SMATV only)

To confirm the selections you made and advance to the Search Channels page.

Digital Satellite Receiver Page 4 - 9