8 - ZONE INFORMATION
8.9A MSG: TROUBLE
A T L -
MESSAGE TO TRANSMIT
You can send two report types to the receiver: Alarm and Trouble. These are represented by the characters A and T. Press any top row SELECT key to display the zone's report options.
ALARM - Selecting A, allows an alarm report to be sent to the receiver and the bell output to activate according to zone type. See section 7.4, Bell Action. The zone name appears in the panel's alarmed zones status lists.
TROUBLE - Selecting T allows a trouble report to be sent to the receiver and the zone name to appear in the panel's alarmed zones status lists.
LOCAL - When you select L, an alarm report is NOT sent to the receiver. The bell output still activates according to zone type and the zone name appears in the panel's alarmed zones status lists. NOTE: If Pager is YES in Communication, the alarm report is also sent to the designated pager.
8.9B
OUTPUT NO: 0
OUTPUT NUMBER
8.9C
ACTION:
STD PLS MOM FOLW
You can specify any of the outputs on the XR10 to be activated by a zone condition. The output can be activated regardless of the report to transmit or whether or not the zone is programmed as local. An output activated by a
To enter an Output Number, press a top row SELECT key followed by the output number 1 to 4. Press the COMMAND key.
OUTPUT ACTION -
Entering an Output Number in section 8.9B displays this prompt that allows you to assign an output action to the relay.
A description of the available output actions is given below:
STEADY - The output is turned on and remains on until the area is disarmed, an output cutoff time expires, or the output is reset from the keypad User Menu.
PULSE - The output alternates one second on and one second off until the area is disarmed, an output cutoff time expires, or the output is reset from the keypad User Menu.
MOMENTARY - The output is turned on only once for one second.
FOLLOW - The output is turned on and remains on while the zone is in an off normal, or bad condition. When the zone restores, the output is turned off.
After you've made the three selections in sections 8.9A through 8.9C, the display prompts you for the same three selections for Disarmed Short, Armed Open, and Armed Short conditions. If the zone is a 24 hour type, only the Armed Open and Armed Short conditions are displayed. When you've programmed all of the zone conditions, the Swinger Bypass selection is then displayed.
8.10
SWGR BYP | YES |
SWINGER BYPASS
YES allows the zone to be bypassed by the panel after three alarm, trouble, or local trips within one hour. Selecting NO disables swinger bypassing for this zone.
After the first trip, if the zone does not trip 2 more times before the remaining time expires, the bypass trip counter returns to zero and the zone must trip a full 3 times within the next hour to be automatically bypassed.
A swinger bypass is sent to the receiver if Bypass Reports is YES. See section 5.5.
Bypassed zones are automatically reset when the area they’re assigned to is disarmed. All 24 hour zones are reset when the system is disarmed.
XR10 Programming Guide
2841 E. Industrial Drive Springfield, MO
14
