DMP Electronics Command Processor Panel, XR10 11.1Status List, 11.2False Alarm Reduction Features

11 - APPENDIX

11.1Status List

The Status List is the current status of the system or records of recent system events that are displayed on the alphanumeric keypads. For example, in Home/Away systems, you might see the display SYSTEM READY. This would be the current status of the system.

If an event were to occur on the system, such as an AC failure, the keypad would also display the AC POWER - TRBL message. This is a system event that is placed into the Status List to alert the user to a problem with the system.

Some Status List items remain in the display until manually cleared and some are cleared automatically when the condition returns to normal. Below is a complete list of status and event displays the keypad can show in the Status List:

Description	Must be manually cleared?
Fire and Supervisory zone alarms	Yes - by Sensor Reset
Fire and Supervisory zone troubles	No - clears when zone restores
Burglary zone alarms	No - clears after 8 minutes or at disarming.
All other zone alarms	No - clears when zone restores
Zone monitor displays	No - clears after 8 minutes
Day zone alerts	No - clears after 8 minutes
System monitor troubles	No - clears when condition restores
(AC and battery trouble)
Armed status display	No
(System On)
Disarmed status displays	No
(System Ready, System Not Ready)
Remote keypad messages	No
(Sent to the keypad by your office or central station)

Each item in the list is displayed for four seconds. When there are multiple items in the list, you can use the COMMAND or ARROW keys to scroll forward or back through the items.

11.2False Alarm Reduction Features

System Recently Armed report

The System Recently Armed report (S78) is sent when a burglary zone is placed into alarm within five minutes of the system being armed.

Exit Error report

The Exit Error report is sent when an Exit zone is in a bad condition at the end of the Exit Delay time.

11.34-2 reporting operation

When using the 4-2 reporting format, the panel follows this sequence to report to the receiver.

1.The panel dials the receiver phone number and waits for a response.

2.If the panel detects it is communicating with a 4-2 compatible receiver, all reports except those that can only be sent in SDLC are sent to the receiver.

3.If the panel detects it is communicating with a DMP SCS-1 Receiver, all reports are then sent in SDLC format.

4.If the panel last communicated to a 4-2 compatible receiver, a SDLC event cannot initiate a call to the receiver.

5.If the panel last communicated to a DMP SCS-1 Receiver, any reporting event can initiate a call to the receiver.

XR10 Programming Guide

2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282

17