Eaton Electrical QSNAP user manual Out of Box Operation, Default Input Data from Qsnap, Bit

Intelligent Technologies (IT.) QSNAP

February 2002

Operation

This section provides details about the following features and aspects of QSNAP operation:

●“Out of box” operation

●Typical application

●Enhanced features

●Input/output data

●Status LED

●Truth table

“Out of Box” Operation

When the QSNAP is properly installed and has a properly configured Group ID, as per the

“Installation” section, the following default data lists will be presented to the system for use by a gateway.

For further information on the meaning of the terms in the assemblies, see the “Enhanced Features” section on Page 10.

Table 6: Default Input Data from QSNAP

Bit 7	Bit 6	Bit 5		Bit 4	Bit 3	Bit 2	Bit 1	Bit 0
		3-Phase Average RMS Current LSB							Byte 0
			3-Phase Average RMS Current						Byte 1
			3-Phase Average RMS Current						Byte 2
		3-Phase Average RMS Current MSB							Byte 3
			% Thermal Capacity LSB						Byte 4
			% Thermal Capacity MSB						Byte 5
			Fault/Warning Codes LSB						Byte 6
			Fault/Warning Codes MSB						Byte 7
Reserved	Warning	Faulted		Local	Resetting	Permissive	Running	Running	Byte 8
				Control			2	1

Table 7: Default Output Data to QSNAP

Bit 7	Bit 6	Bit 5	Bit 4	Bit 3	Bit 2	Bit 1	Bit 0
Reserved	Reserved	Local	Local/	Fault	Permissive	Run 2	Run 1	Byte 8
		Control	Remote	Reset

8 Pub. No. MN05001001E