Intelligent Technologies (IT.) QSNAP
February 2002
Input/Output Data
The QSNAP offers a standard data list (shown below) for default operation. The list is
configurable with data contained within Table 21 in Appendix A: QSNAP Parameters, using the CH Studio application.
Input Data
Use Tables 10 and 11 when setting up the QSNAP input data.
Table 10: Input Assembly Data Definitions
Data | Description | ||
|
| ||
|
| ||
Faulted/Trip | The motor controller is faulted or tripped | ||
|
| ||
Warning | The motor controller has a warning of an impending trip | ||
|
| ||
Running 1 | The first motor controller is running | ||
|
| ||
Running 2 | The second motor controller is running | ||
|
| ||
Permissive | The motor controller run/stop permissive | ||
|
| ||
Resetting | Motor controller is in the process of resetting a fault | ||
|
| ||
Thermal Capacity | % thermal capacity of the motor from 0 to 100% | ||
|
| ||
RMS Average | Average RMS current of the motor (0.000A) | ||
Current |
|
| |
|
| ||
Fault Codes and | Valid fault and warning codes are: | ||
Warning Codes |
|
| |
0 | No Fault | ||
| |||
|
|
| |
| 1 | General Fault | |
|
|
| |
| 2 | Firmware Fault | |
|
|
| |
| 3 | Interdevice Communication Fault | |
|
|
| |
| 4 | Control Voltage Low Fault | |
|
|
| |
| 5 | Control Device Overtemperature Fault | |
|
|
| |
| 6 | Motor Phase Loss Fault | |
|
|
| |
| 7 | Motor Phase Imbalance Fault | |
|
|
| |
| 8 | Motor Ground Fault | |
|
|
| |
| 9 | Motor Underload Fault | |
|
|
| |
| 10 | Motor Overcurrent Fault | |
|
|
| |
| 13 | Motor Bypass Failure Fault | |
|
|
| |
| 14 | Motor Thermal Pile Fault | |
|
|
| |
| 15 | Control Device Test Fault | |
|
|
| |
| 40000 | Current Threshold Warning | |
|
|
| |
| 40001 | Underload Warning | |
|
|
| |
| 40002 | Control Device Overtemperature Warning | |
|
|
| |
| 40003 | Overload Warning | |
|
|
| |
Pub. No. MN05001001E | 11 |
