HEDGE CLIPPER 15

OPERATOR'S MANUAL

ASSEMBLY (HCA-2400, SHC-2100,2400)SHC-1700 is Factory Assembled in the box.SHC-2100,2400GEAR HOUSING ASSEMBLY/DRIVE SHAFT(SHC-2400,HCA-2400)

Tools Required: 8mm x 10mm Open End Wrench, 4 mm Hex Wrench

Parts Required: Power Head/Drive Shaft Assembly and Gear Housing

Assembly.

NOTE

Hedge Clipper Blades are very sharp. Wear gloves to protect hands.

HCA-2400

1.Slide the Gear Housing Assembly on the Drive Shaft. Be certain the Flex Drive Shaft engages the hole in Driver Gear.

2.Align the locating screw (A) with the locating hole (B) in the Drive Shaft Housing, tighten screw (A) and clamping screws (C).

POWER HEAD/DRIVE SHAFT(SHC-2400,HCA-2400Only)

1.Stand engine upright on a level surface.

2.Loosen the two bolts at engine drive shaft end.

3.Carefully fit drive shaft assembly to engine, making sure that inner drive shaft engages into clutch mount.

NOTE

 

 

The arrow on the drive shaft housing must be in contact with the

 

A

engine (arrow on drive shaft indicates line).

 

 

 

 

 

 

 

 

4.Rotate the drive shaft housing until arrows are centered with engine bearing housing.

5.Tighten bolts (A).