HEDGE CLIPPER 31 OPERATOR'S MANUAL

Drive Shaft Assembly

NOTE

Hedge Clipper drive shaft should be greased every 25-50 hours of operation.

Tools required: 8 mm Open End Wrench, Screwdriver, Clean Rag, SmallBrush.

Parts required: Lithium Based Grease.

WARNING DANGER

Blades are very sharp. Wear gloves to protect hands, otherwise serious personal injury may result.

1.Loosen gear housing assembly locating screw (A) and mounting screws (C). Remove the gear box from the drive shaft housing.

2.Pull the drive shaft (B) from the housing, wipe clean and re-coat with a thin coating [1/2 oz. (15 ml)] of lithium based grease.

3.Slide the drive shaft back in the drive housing being careful not to get dirt on the flex shaft.

4.Install the gear housing assembly.

SHC-1700, A

2100,2400 C

HCA-2400

B

SHARPENING BLADES

Level2.

Tools required: Flatfile,SmallScrewdriver

Parts required: Lithium Based Grease.

NOTE

Hedge Clipper Blades are very sharp. Wear gloves to protect hands.

1.Use screwdriver to separate upper and lower cutters equal distance apart.

2.File each edge carefully. Follow the original shape of the blade.

IMPORTANT

If a power grinder is used DO NOT allow blade to over heat.

3.Lubricate blades. See "Blade Lubrication Instructions", page 30 this section.