HEDGE CLIPPER 27 OPERATOR'S MANUAL
1.Remove spark plug lead from the spark plug and throttle linkage end from the carburetor swivel.
2.Remove the four screws that retain the engine cover. Two at the top of the starter, two on either side of the front. Lift the cover from the engine and lay to the front of the hedge clipper.
NOTE
The throttle linkage remains assembled to the engine cover and the spark plug lead and grommet remain installed.
3.Use the wooden stick or brush to remove dirt from the cylinder fins.
4.Remove grass and leaves from the grid between the recoil starter and fuel tank.
5.Assemble components in reverse order.
NOTE
When installing the engine cover, be certain the tab of the metal deflector shield is in the slot of the cover.
EXHAUST SYSTEM
Spark Arrestor Screen
Level2.
Tools Required: Cross Head Screwdriver. Soft metal brush.
Parts Required: ScreenP/N14586240630,GasketLidP/N14586642031
1.Remove engine cover (A). See "Cleaning Cooling System" pages 26 and 27 for step by step instructions.
2.Place piston at Top Dead Center (TDC) to prevent carbon/dirt from entering cylinder.
3.Remove spark arrestor screen cover (B), screen holder (C), gasket
(D) and screen (E) from muffler body.
4.Clean carbon deposits from screen and muffler components.
5.Replace screen if it is cracked, plugged or has holes burned
through. | E |
6.Assemble components in reverse order.
NOTE
When installing the engine cover, be certain the tab of the metal deflector shield is in the slot of the cover.
D
C
B