Echo HCA-2400 (SHC-2400, HCA-2400), THROTTLE LINKAGE INSTALLATION

16

THROTTLE LINKAGE INSTALLATION

(SHC-2400, HCA-2400)

NOTE

The engine is delivered separated from shaft tube. The throttle linkage and stop switch wires are attached to the rear handle.

1.Close choke and remove air filter cover.

2.Loosen outer 10mm nut (A) on throttle linkage.

3.Insert throttle linkage in fan cover slot (B).

4.Finger tighten nut (A) and attach the inner linkage to the swivel (C) on the carburetor throttle plate.

NOTE

It is important that the head of the throttle linkage fits inside the slot well of the swivel (C).

5.Tighten the 10mm linkage nuts (A).

6.Check throttle for freedom of movement and make sure it returns to idle position. If the throttle cable does not allow the carburetor throttle plate (D) to return to idle against idle screw (E), loosen cable nuts; turn throttle cable nut (A) counter clockwise until throttle plate (D) rests against idle screw (E). Hold cable nut (A) from turning and tighten other cable nut.

6.Connect ground wire terminal under screw on fan housing.

7.Connect stop switch wire to stop wire on engine.

8.Install air filter and cover.

C D E

A B

B

G

A

F