Wireless Local Area Network (WLAN) Module Using CF Radio

The following section only applies when the CF (Compact Flash) WLAN module (With FCC ID: I28MD-QL4137) is installed in a QL series printer (note that only one of the radio options can be installed in the printer at one time). The FCC ID number label is on the front of the module and can be read with the module installed.

WARNING: Use of a QL series printer with the radio module marked “with FCC ID: I28MD-QL4137” meets the FCC requirements for radio frequency (RF) radiation exposure in the standard body worn configuration with no minimum separation. In this configuration, which applies whether the belt clip or shoulder strap is used, the face of the printer from which paper is transported is facing away from the user’s body. The standard configuration must always be used when the printer is body worn.

QL 220, QL 320 and QL 420 printers with this radio option have been SAR tested. The maximum SAR value measured for each model was 1.1W/kg averaged over 1 gram.

European Regulatory Information for this Radio

AUS B DK FIN

F D GR IRE

I LUX NL P

E S UK

Note: -Member states in the EU with restrictive use for this device are crossed out!

This device is also authorized for use in all EFTA member states (CH, ICE, LI, NOR)

0982

 

Important Notice:

 

This device is a portable RF printer intended

 

for commercial and industrial use in all EU and

 

EFTA member states except in France where

 

restrictive use applies.

 

 

 

Europe – EU Declaration of Conformity

This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test methods have been applied in order to prove presumption of compliance with the R&TTE Directive 1999/5/EC:

• EN 60950: 2000

Safety of Information Technology Equipment

• EN 300 328-2 V1.2.1 (2001-12)

Technical requirements for spread-spectrum radio equipment

• EN 301 489-17 V1.2.1 (2002-08)

continued

31

QL Series User Guide