Frequency Hopping Wireless Local Area Network (WLAN) Module Using PCMCIA Radio(QL 320 and QL 420 only)

The following section only applies when the PCMCIA FH WLAN module (FCC ID: I28MD- QL3201) is installed in a QL 320 or QL 420 printer (note that only one of the radio options can be installed in a printer at one time). The FCC ID number label is on the front of the module and can be read with the module installed.

WARNING: Use of the QL 320 or QL 420 with the radio module marked with FCC ID: I28MD-QL3201 meets the FCC requirements for radio frequency (RF) radiation exposure in the standard body worn configuration with no minimum separation. In this configuration, which applies whether the belt clip or shoulder strap is used, the face of the printer from which paper is transported is facing away from the user’s body. The standard configuration must always be used when the printer is body worn. This configuration maintains the required 1 cm separation distance.

The QL 320 and QL 420 with this radio option have been SAR tested. The maximum SAR value measured for the QL 320 was .604 W/kg averaged over 1 gram.

The maximum SAR value measured for the QL 420 was .899 W/kg averaged over 1 gram.

European Regulatory Information for this Radio

AUS B DK FIN

F D GR IRE

I LUX NL P

E S UK

Note: -Member states in the EU with restrictive use for this device are crossed out! This device can only be used indoors in France.

This device is also authorized for use in all EFTA member states (CH, ICE, LI, NOR)

Important Notice:

0336 This device is a portable RF printer intended for commercial and industrial use in all EU and EFTA member states except in France where restrictive use ap- plies.

continued

37

QL Series User Guide