|
| also use a pen or pin to press the ‘RESET’ button located at the |
|
| back of projector server. |
| 6. | Ask your network administrator or a qualified technician for help. |
|
|
|
The image | 1. | Make sure the video cable is securely connected to ‘VGA’ jack at |
displayed on |
| the back of the projector server. You may also check the video |
projector or CRT / |
| connection to the projector or CRT/LCD monitor. |
LCD monitor is | 2. | Make sure the projector or CRT/LCD monitor works with the video |
distorted |
| output setting of projector server. You can change to a lower |
|
| resolution and see if the display on projector or CRT/LCD monitor |
|
| becomes normal (see Chapter 5.7 for detailed instructions for |
|
| changing the output resolution). |
| 3. | Replace the video cable used to connect the projector server and |
|
| your projector or CRT/LCD monitor with a new one. |
| 4. | Contact your projector or CRT/LCD monitor manufacturer for help. |
The wireless | 1. | If you’re using this projector server in an extremely big room, you |
signal reception is |
| may wish to try another antenna with high signal gain for better |
bad |
| signal reception. Contact your dealer of purchase for detailed |
|
| information. DO NOT ATTEMPT TO REAPLCE THE ANTENNA |
|
| BY YOURSELF IF YOU’RE NOT SURE WHAT ANTENNA YOU |
|
| SHOULD USE! |
| 2. | Move your computer closer to the projector server if possible, or |
|
| use wired connection. |
| 3. | The wireless antenna on the projector server should be |
|
| perpendicular to the ground for better reception. |
Cannot connect | 1. | If you set the projector server to use wireless encryption, all |
wirelessly to the |
| wireless clients should input the correct WEP key before they can |
projector server |
| get connected. |
| 2. | Make sure the SSID of the projector server is found by your |
|
| computer, and you connect to the correct SSID for the projector |
|
| server. |
| 3. | Reboot your computer and try again. |
No audio | 1. | Check the volume setting of your computer and your audio |
|
| speaker / amplifier. |
| 2. | Check the audio cable that connects the projector server and your |
|
| audio speaker / amplifier. |
| 3. | Replace the audio cable with a new one. |
45
