Controlling the Projector via LAN

After connecting the projector to your network, enter the projector IP address in “Address” on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup screen that will enable control of the projector via the network.

Controlling the ProjectorUsing Internet Explorer(Version 5.0 or later)

Complete connections to external equipment before starting the operation. (See pages 24- 36 on the owner’s manual of the projector.)

Complete the AC cord connection. (See page 37 on the owner’s manual of the projector)

Note

When connecting the projector to the LAN, use a commercially available LAN cable (UTP cable, Category 5, cross-over type). When connecting the projector to a hub, use a straight-through cable.

1

2

Start Internet Explorer (version 5.0 or later) on the computer.

Enter “http://” followed by the projector IP address set by the procedure on page 22 followed by “/” in “Address”, and then press the “Enter” key.

The default setting (“DHCP Client” is set to “OFF” on the projector) for IP address is “192.168.150.2”. If you did not change the IP address in “3. Setting up a Network Con- nection for the Projector” (pages 21-22), enter “http://192.168.150.2/”.

3 A screen for controlling the projector appears, ready for performing various status condi- tions, control, and settings.

23