Video Wall Projection
■Preparation
•Follow the procedure below after setting up the basic connection.
•When “User Name” and “Password” have been set to the projector, reset them before the stack projection
setup. To set “User Name” and “Password”, use the same user name and password for both of the master and slave projectors. (See page 25.)
•Set “Data Port” with the same number for both of the master and slave projectors. (See page 26.)
Info
•Do not use network software or equipment while it is accessing the projector via the port of the same number used for the master or slave projector, otherwise you cannot properly control multiple projectors with one remote control.
1
Change the TCP/IP settings for the computer as shown below.
(See “Setting an IP Address for the Computer” on page 19 for the details.)
• IP address | : 192.168.150.2 |
• Subnet mask | : 255.255.255.0 |
• Default gateway : (Do not input any values.)
Note
•The TCP/IP settings shown are examples to make connections following the diagram.
•When using other equipment in the same network, be careful about the IP address overlap or other network settings.
•Consult your network administrator for as- sistance with the network settings.
2
Change the TCP/IP settings for | 3 |
| ||
| ||||
each projector as shown below. | Connect the computer and the pro- | |||
(See “Setting up a Network Connection for the |
| jectors as shown below. | ||
Projector” on page 21 for the details.) |
|
| ||
• IP address | Projector 1 : 192.168.150.3 |
|
| |
| Projector 2 | : 192.168.150.4 |
|
|
| Projector 3 | : 192.168.150.5 |
|
|
| Projector 4 | : 192.168.150.6 |
|
|
• Subnet mask |
| : 255.255.255.0 |
|
|
• Default gateway | : 0.0.0.0 |
|
| |
Projector 1: Master
Projector 2: Slave
LAN terminal
Computer
LAN cable
LAN terminal
Projector 3: Slave
Hub
LAN terminal
Projector 4: Slave
LAN cable
LAN terminal
47