Eiki EIP-WX5000 Click the “Apply” button, Setting up the Projector Network Environment

Setting up the Projector Network Environment

4 The TCP/IP setting screen ap- pears, ready for network settings for the projector.

Items	Setting example / Remarks
DHCP	Select “ON” or “OFF” to determine
Client	whether to use DHCP Client.
IP Address	You can set this item when “DHCP
	Client” is set to “OFF”.
	Factory default setting: 192.168.150.2
	Enter an IP address appropriate
	for the network.
Subnet	You can set this item when “DHCP
Mask	Client” is set to “OFF”.
	Factory default setting: 255.255.255.0
	Set the subnet mask to the same
	as that of the computer and
	equipment on the network.
Default	You can set this item when “DHCP
Gateway	Client” is set to “OFF”.
	Factory default setting: 0.0.0.0
	* When not in use, set to “0.0.0.0”.
DNS	Factory default setting: 0.0.0.0
Server	* When not in use, set to “0.0.0.0”.

Note

•Confirm the existing network’s segment (IP address group) to avoid setting an IP ad- dress that duplicates the IP addresses of

other network equipment or computers. If “192.168.150.2” is not used in the network having an IP address of “192.168.150.XXX”, you don’t have to change the projector IP address.

•For details about each setting, consult your network administrator.

5

6

Click the “Apply” button.

The set values appear. Confirm that the values are set properly, and then click the “Confirm” but- ton.

•Close the browser.

•This completes the network settings.

•After setting items, wait for 10 seconds and then re-access.

•Change the IP address of the setting computer back to its original address, which you have noted down in Step 6-1on page 23, and then connect the computer and the projector to the network.

25