Eiki EIP-WX5000 Setting the Projector Using RS-232C or Telnet, When Connecting Using RS-232C

Setting the Projector Using RS-232C or Telnet

Connect the projector to a computer using RS-232C or Telnet, and open the SETUP MENU on the computer to carry out various settings for the projector.

When Connecting Using RS-232C

1 Launch general purpose terminal emulator.

2 Input settings for the RS-232C port of the terminal emulator as follows.

Baud Rate	: 9600 bps*
Data Length	: 8 bit
Parity Bit	: None
Stop Bit	: 1 bit
Flow Control	: None

*This is the factory default setting. If the value of Baud Rate for the projector has been changed, set Baud Rate here according to the changed value on the projector.

3 Input“PJS11234”and press the“En- ter” key.

7 “Password:” is displayed. Input the password and press the“Enter” key.

•If a password has not yet been set, just press the “Enter” key.

8 Input “setup” and press the “Enter” key.

•SETUP MENU will be displayed.

▼SETUP MENU

---------------------------------	SETUP MENU--------------------------------
[1]IP Address	[2]Subnet Mask	[3]Default Gateway
[4]User Name	[5]Password
[6]RS-232C Baud Rate	[7]Projector Name	[8]DHCP Client
[A]Advanced Setup		[D]Disconnect All
[V]View All Setting	[S]Save & Quit	[Q]Quit Unchanged
setup>

Note

•User name and password are not set in the fac- tory default settings.

•If the user name or password is entered incor- rectly three times, SETUP MENU will be quit.

4 “OK”is displayed. Input“PJS25678” and press the “Enter” key within 10 seconds.

5 “OK” is displayed. Press the “En- ter” key.

6

“User Name:”is displayed. Input the user name and press the “Enter” key.

•If a user name has not yet been set, just press the “Enter” key.

31