Eiki EIP-WX5000L Preparation, Follow the procedure below after setting up the basic connection

Video Wall Projection

■Preparation

•Follow the procedure below after setting up the basic connection.

•When “User Name” and “Password” have been set to the projector, reset them before the stack projec-

tion setup. To set “User Name” and “Password”, use the same user name and password for both of the master and slave projectors. (See page 28.)

•Set “Data Port” with the same number for both of the master and slave projectors. (See page 29.)

Info

•Do not use network software or equipment while it is accessing the projector via the port of the same number used for the master or slave projector, otherwise you cannot properly control multiple projectors with one remote control.

1 Change the TCP/IP settings for the computer as shown below.

(See “Setting an IP Address for the Computer” on page 22 for the details.)

• IP address	: 192.168.150.2
• Subnet mask	: 255.255.255.0

• Default gateway : (Do not input any values.)

Note

•The TCP/IP settings shown are examples to make connections following the diagram.

•When using other equipment in the same network, be careful about the IP address overlap or other network settings.

•Consult your network administrator for as- sistance with the network settings.

2 Change the TCP/IP settings for			3 Connect the computer and the pro-
each projector as shown below.
(See “Setting up a Network Connection for the			jectors as shown below.
Projector” on page 24 for the details.)
• IP address	Projector 1 : 192.168.150.3
	Projector 2	: 192.168.150.4
	Projector 3	: 192.168.150.5
	Projector 4	: 192.168.150.6
• Subnet mask		: 255.255.255.0
• Default gateway		: 0.0.0.0

Projector 1: Master

Projector 2: Slave

Projector 3: Slave

Projector 4: Slave

LAN terminal

Computer

LAN cable

LAN terminal

Hub

LAN terminal

LAN cable (straight-through type)

LAN terminal

50