Eiki EIP-WX5000L Setting and Adjusting the, Setting the Security, Network - Security

Controlling the Projector via LAN

Setting and Adjusting the

Projector (Settings & Adjustments)

Example: “Picture” screen display for COMPUTER1

On these screens, you can make projector settings or adjustments.You can set or adjust the following items :

• Picture Mode	• Auto Search
• CLR Temp	• Auto Power Off
• Progressive	• Password
• C.M.S. Adjustment	• Lamp Mode
• DNR	• Lens Type
• Signal Type	• Projection Mode
• Dynamic Range	• Keylock Level
• Color Space	• Set Inputs
• Auto Sync	• Fan Mode
• Auto Sync Disp	• Auto Restart
• Audio Out	• RS-232C Speed

•Internal Speaker • Monitor Out (Standby)

• Resize	• Video Wall
• OSD Display	(See page 44.)
• Video System	• Stack Setting
(VIDEO/S-VIDEO)	(See page 41.)
• Background	• All Reset
• Startup Image	• OSD Language

•Eco Mode

Note

•If you click the “Refresh” button before the screen is displayed completely, an error message (“Server Busy Error”) will be dis- played. Wait for a moment and then oper- ate again.

•You cannot operate this page while the pro- jector is warming up.

•While the projector is in standby mode, you can only control “Power ON”.

•For details about each item, refer to the owner’s manual of the projector.

•For details about the items that will be initialized in “All Reset”, refer to the owner’s manual of the projector. (The network set- ting items will not be initialized.)

Setting the Security

(Network – Security)

On this screen, you can make settings relat- ing to security.

	Items	Description
User Name		Setting of user name for
		security protection.
Password		Setting of password for
		security protection.
Accept IP		It is possible to set up to three
Address		IP addresses allowing connec-
		tion to the projector.
	All IP	No limits are set to IP addresses
	Addresses	connecting to the projector.
From only	For security improvement, only an
	specific IP	IP address set by “Address 1-3”
	addresses	can be connected to the projector.

After clicking the “Apply” button, the set val- ues appear. Confirm that the values are set properly, and then click the “Confirm” button.

Note

•After setting items, wait for 10 seconds and then re-access.

•User Name and Password can be up to 8 characters.

•You can input the characters below : a-z, A-Z, 0-9, -, _

•To cancel User Name and Password, enter nothing and then press “Apply” button.

28