Eiki LC-SD10 Preparation, Connecting the AC Power Cord, Projector side, AC Outlet side

Preparation

Connecting the AC Power Cord

This projector uses nominal input voltages of 100-120 V or 200-240 V AC. This projector automatically selects the correct input voltage. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce risk of electrical shock, do not plug into any other type of power system.

Consult your authorized dealer or service station if you are not sure of the type of power supply being in use.

Connect a projector with a peripheral equipment before turning a projector on. (Refer to page 15 –16 for connection.)

CAUTION

For safety, unplug the AC Power Cord when an appliance is not used. When this projector is connected to the outlet with the AC Power Cord,

an appliance is in Stand-by Mode and consumes a little electric power.Connect AC Power Cord (supplied) to the projector. The AC outlet must be near this equipment and must be easily accessible.

Note:

AC Power Cord must meet requirement of the country where you use the projector.

Confirm an AC plug type with the chart below and proper AC Power Cord must be used.

If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.

Projector side	AC Outlet side
	For the U.S.A. and Canada	For Continental Europe
	Ground
To POWER CORD	To the AC Outlet.	To the AC Outlet.
CONNECTOR on your
projector.	(120 V AC)	(200 - 240 V AC)

12