Eiki LC-SD10 owner manual Setting, Ceiling function Rear function Power management

Setting

Ceiling

When this function is “On,” picture is top / bottom and left / right reversed. This function is used to project the image from a ceiling mounted projector.

Rear

When this function is “On,” picture is left / right reversed. This function is used to project the image to a rear projection screen.

Power management

For reducing power consumption as well as maintaining the lamp life, the Power Management function turns off the projection lamp when the input signal is interrupted and no button is pressed for 30 seconds or more.

If the input signal is interrupted and no button is pressed for 30 seconds or more, the timer display with the message " No signal " appears on the screen. The count-down of the set time will get started. The count-down time can be set between 1 and 30 minutes.

When the count-down time has been elapsed, the lamp will be turned off to cool itself down. The POWER indicator is flashing red during this cooling-off period. The next operation depends on the setting as follows :

Ready . . . . . . . . When the lamp has been fully cooled down, the POWER indicator changes to green flashing. In this condition, the projection lamp will be turned on if the input signal is reconnected or any button on the top control or remote control is pressed.

Shutdown . . . . . When the lamp has been fully cooled down, the power will be turned off.

Off . . . . . . . . . . . The Power Management function is canceled.

Ceiling function

Rear function

Power management

Press the SELECT button at Power management to show this box. Choose one of three settings with the Point 78 button, and navigate to the timer with the Point ed button and set time with the Point 78button.

Time left until Lamp off

Lamp mode Lamp mode

This function allows you to change brightness of the screen.

···· normal brightness
···· the controlled brightness according with input signal
···· lowers brightness, reduces the lamp power consumption,
and extends the lamp life.	Press Point 78buttons to
	select lamp mode.

37