Eiki LC-SD10 To change the code of the projector, To change the code of the remote control

Setting

Remote control

This projector has two different remote control codes; the factory- set normal code (Code 1) and the secondary code (Code 2). This switching function prevents remote control interference when operating several projectors or video equipment at the same time.

When operating the projector in “Code 2,” both the projector and remote control must be switched to “Code 2.”

To change the code of the projector :

Set the remote control in the SETTING MENU to “Code 2.”

To change the code of the remote control :

Press and hold both MENU and IMAGE buttons on the remote control together for 10 seconds or more. After changing the code, make sure the remote control operates properly.

To return to the normal code (Code 1), operate both the projector and remote control in the ways above again.

Note : When battery of the remote control is replaced, the remote control code automatically returns to the normal code (Code 1).

Remote Control

Press and hold

MENU VOLUME- SELECT VOLUME+ MENU and IMAGE

buttons for 10 seconds

or more.

D.ZOOM PAGE KEYSTONE NO SHOW

AUTO PC P-TIMER

IMAGE FREEZE MUTE

USB

This projector is equipped with the USB port for interactive operation between the projector and computer. Selects either of the followings as needed.

···· When using the PAGE ed buttons on the remote control. ( ☞ P10 )

···· When controlling the projector with a computer.

This item is provided for future use. Not available now.

Key lock

This function locks operation of the top control and remote control.

It is useful to prevent operation by a third person.

···· Not locked.

···· Locks operation of the top control.

To unlock, use the remote control.

···· Locks operation of the remote control.

To unlock, use the top control.

If the top control accidentally becomes locked and you do not have the remote control nearby, disconnect the AC power cord to turn off the power, and then while pressing the SELECT button, reconnect the AC power cord. This will unlock the top control operation.

Lamp counter reset

This function is used to reset the lamp replace counter. When replacing the projection lamp, reset the lamp replace counter by using this function. Refer to page 41 for operation.

Factory default

This function returns all setting values except for the lamp counter to the factory default settings.

Key lock

Select Key lock to display this box. Choose one of these with the Point ed button and select [Yes] to activate it.

Factory default

Select Factory default to show this box. Select [Yes] to activate it.

38