Eiki LC-W3 Before Operation Remote Control Batteries Installation, Operating Range

BEFORE OPERATION

REMOTE CONTROL BATTERIES INSTALLATION

1	Remove battery
	compartment lid.

Pull up lid and remove it.

2	Slide batteries into	3	Replace compartment lid.
	compartment.

Two AA size batteries For correct polarity (+ and

–), be sure battery terminals are in contact with pins in compartment.

To insure safe operation, please observe following precautions :

●Use (2) AA or R06 type alkaline batteries.

●Replace two batteries at same time.

●Do not use a new battery with an used battery.

●Avoid contact with water or liquid.

●Do not expose Remote Control Unit to moisture, or heat.

●Do not drop Remote Control Unit.

●If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries.

●Danger of explosion if battery is incorrectly replaced.

●Dispose of used batteries according to batteries manufacturers instructions and local rules.

Operating Range

Point Remote Control Unit toward projector (Infrared Remote Receiver) whenever pressing any button. Maximum operating range for Remote Control Unit is about 16.4’ (5m) and 60° in front and rear of a projector.

16.4’ (5 m)

60°

16.4’ (5 m)

60°

16