APPENDIX
LAMP REPLACEMENT
LAMP REPLACE
When the life of the Projection Lamp of this projector draws to an end, |
| |
TOP CONTROL | ||
the LAMP REPLACE indicator lights yellow. If this indicator lights | ||
| ||
yellow, replace the projection lamp with a new one promptly. |
|
This indicator lights yellow when the life of the projection lamp draws to an end. Replace the Projection Lamp with a new one promptly.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| CAUTION |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Allow a projector to cool, for at least 45 minutes before | For continued safety, replace with a lamp assembly of | |||||||
| you open Lamp Cover. The inside of a projector can |
| the same type. |
| ||||
| become very hot. |
| Do not drop a lamp assembly or touch a glass bulb! The |
| ||||
|
|
|
| glass can shatter and may cause injury. |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Follow these steps to replace lamp assembly.
1 | Turn off a projector and disconnect AC plug. Allow a projector to |
| cool for at least 45 minutes. |
2 | Loosen 2 screws with a screwdriver and open Lamp Cover. |
3 | Loosen 2 screws with a screwdriver and pull out Lamp Assembly |
| by grasping Handle. |
4 | Replace Lamp Assembly with a new one and tighten 2 screws |
| back. Make sure that Lamp Assembly is set properly. Replace |
| Lamp Cover and tighten 2 screws. |
5 | Connect AC Power Cord to a projector and turn it on. |
6 | Reset Lamp Replace Counter (refer to next page “LAMP |
| REPLACE COUNTER” section). |
NOTE : Do not reset Lamp Replace Counter when Projection Lamp is not replaced.
| LAMP COVER |
LAMP | HANDLE |
ASSEMBLY |
|
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following information to the dealer.
● | Model No. of your projector | : |
|
● | Replacement Lamp Type No. | : |
|
|
|
| (Service Parts No. 610 325 2957) |
46
