Eiki LC-W3 Appendix Air Filter Care And Cleaning, Cleaning Projection Lens, Recommendation

APPENDIX

AIR FILTER CARE AND CLEANING

Air Filter prevents dust from accumulating on surface of Projection Lens and Projection Mirror. Should Air Filter become clogged with dust particles, it will reduce Cooling Fans’ effectiveness and may result in internal heat build up and adversely affect life of a projector. Clean Air Filter following steps below:

1	Turn off a projector, and disconnect AC power cord from AC
	outlet.
2	Turn a projector upside down and remove Air Filter (2 used) by
	pulling latches upward.
3	Clean Air Filter with a brush or wash out dust and particles.
4	Replace Air Filter properly. Make sure that Air Filter is fully
	inserted.

CAUTION

Do not operate a projector with Air Filter removed. Dust may accumulate on LCD Panel and Projection Mirror degrading picture quality.

Do not put small parts into Air Intake Vents. It may result in malfunction of a projector.

AIR FILTER

Pull up and remove.

RECOMMENDATION

We recommend avoiding dusty/smoky environments when operating a projector. Usage in these environments may cause poor image quality.

When using under dusty or smoky conditions, dust may accumulate on a lens, liquid crystal panels, or optical elements inside a projector. This condition may degrade quality of a projected image.

When above symptoms are noticed, contact your authorized dealer or service station for proper cleaning.

CLEANING PROJECTION LENS

Follow these steps to clean Projection Lens:

1	Turn off a projector, and disconnect AC power cord from AC outlet.
2	Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth. Avoid using an excessive amount of cleaner.
	Abrasive cleaners, solvents or other harsh chemicals might scratch a surface.

3

4

Lightly wipe a cleaning cloth over Projection Lens.

When a projector is not in use, replace Lens Cover.

45