Basic Operation
Zoom and Focus Adjustment
Rotate the Zoom Ring to zoom in and out.
Rotate the Focus Lever to adjust the focus of the image.
Auto Setup Function
Auto setup function is provided to automatically correct Keystone distortion according to the projector’s tilt and adjust the computer display parameters (Fine sync, Total dots, and Picture position) by just pressing the AUTO SETUP/CANCEL button on the top control or the AUTO SET/CANCEL button on the remote control. The operational setup for the Auto setup can be changed in the Setting menu. Refer to page 47 for the setting of the Auto setup function.
✔Notes:
• Auto Keystone corrects vertical distortion only; it does not correct horizontal distortion.
• Auto Keystone cannot work when Ceiling feature is set to “On” in the Setting menu (p.51).
• Perfect correction of the image distortion cannot be ensured with the Auto setup function. If the distortion cannot be corrected properly by pressing the AUTO SETUP/CANCEL or AUTO SET/CANCEL button, adjust manually by pressing the KEYSTONE button on the remote control or selecting Keystone in the Setting menu (p.48).
• Fine sync, Total dots, Horizontal and Vertical position of some computers cannot be fully adjusted with the Auto PC Adjustment function. When the image is not provided properly with this operation, manual adjustments are required
Keystone Correction
If a projected picture still has keystone distortion after pressing the AUTO SETUP/CANCEL button on the top control or the AUTO SET/CANCEL button on the remote control, correct the image manually as follows:
Press the KEYSTONE button on the remote control. The Keystone dialog box appears. Use the Point ed buttons to correct keystone distortion. The keystone adjustment can be stored (see page 48).
Reduce the upper width | Reduce the lower width | ||||
with the Point e button. | with the Point d button. | ||||
|
|
|
|
|
|
Zoom Ring
Focus Lever
Top Control
AUTO SETUP/CANCEL button
POINT ed buttons
Remote Control
KEYSTONE button
AUTO SET/CANCEL
button
POINT ed buttons
•The white arrows indicate that there is no correction.
•A red arrow indicates the direction of correction.
•An arrow disappears at the maximum correction.
•If you press the KEYSTONE button on the remote control once more while the keystone dialog box is being displayed, the keystone adjustment will be canceled.
•The adjustable range is limited depending on the input signal.
26
