Eiki LC-WB40N owner manual Part Names and Functions Laser Pointer Function, Spotlight

After the Laser pointer has switched to the Pointer, use the LASER button as the Pointer function ON-OFF switch. Press the LASER button pointing toward the projector and see if it lights green.

Part Names and Functions

Laser Pointer Function

This remote control emits a laser beam from the laser light window. Press the LASER button to activate the laser pointer. The signal emission indicator lights red and the red laser beam is emitted. If the LASER button is pressed for more than one minute or if it is released, the laser light goes off.

The laser emitted is a Class II laser. Do not look into the laser light window or point the laser beam at yourself or other people. The following is the caution label for the laser beam.

CAUTION: Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Never look directly into the laser light window while a laser is emitted, otherwise eye damage may result.

The caution label is put on the remote control.

Signal Emission Indicator

Laser Light Window

Pointer Function

You can move the Spotlight or Pointer of the projector with the remote control to emphasize a part of the projected image.

1	Press and hold the MENU and NO SHOW buttons for
	more than 10 seconds to activate the Pointer function.	PRESENTATION POINTER
	(The Laser pointer has switched to the Pointer function.)
2		button
	Press the LASER button on the remote control pointing	MENU button
	toward the projector. The Spotlight or Pointer is
	displayed on the screen with the LASER button lighting	NO SHOW button
	green. Then move the Spotlight or Pointer with the	Press and hold the MENU
	PRESENTATION POINTER button. If the LASER button	and NO SHOW buttons for
	does not light green and continues to emit a laser beam,	more than 10 seconds.
	try the abovementioned procedure until the LASER
3	button lights green.
	To clear the Spotlight or Pointer out the screen, press
	the LASER button pointing toward the projector and see
	if the LASER button lighting is turned off.
	To switch to the Laser pointer again, press and hold	PRESENTATION POINTER
	the NO SHOW and MENU buttons for more than 10	button
	seconds or slide the RESET/ON/ALL-OFF switch to
	“RESET” and then to “ON”.
	When you reset the Pointer function, the remote control	LASER button
	code will be reset, as well.

Spotlight

Pointer

✔Note:

•You can choose the size of Spotlight (Large/Middle/ Small) and the pattern of Pointer (Arrow/Finger/Dot) in the Setting Menu. See “Pointer” on page 53.

14