Setting
Auto setup
This function enables Input search, Auto Keystone correction and Auto PC adjustment by pressing the AUTO SETUP/ CANCEL button on the top control or the AUTO SET/CANCEL button on the remote control. Settings for those functions can be altered as follows:
Input search
This function detects the input signal automatically. When a signal is found, the search will stop. Use the Point ▲▼ buttons to select one of the following options.
Off.......Input search will not work.
On1.....Input search works under the following situation.
–When pressing the AUTO SETUP/CANCEL button on the top control.
–When pressing the AUTO SET/CANCEL button
on the remote control.
On2.....Input search works under the following situation.
– When turning on the projector by pressing the
– When pressing the AUTO SET/CANCEL button on the remote control.
– When pressing the AUTO SETUP/CANCEL button on the top control.
– When the current input signal is cut off.* * If the No show or Freeze function is active, cancel it to
activate the Input search. It is also unavailable when On- Screen menu is displayed.
Auto PC adj..
On . . . Enables Auto PC adjustment when pressing the AUTO SET/CANCEL button on the remote control or the AUTO SETUP/CANCEL button on the top control.
Off . . . Disables Auto PC adjustment.
Auto Keystone
Auto. . . Always works and corrects keystone distortion according to the projector's tilt.
Manual . Works only when pressing the AUTO SETUP/ CANCEL button on the top control or the AUTO SET/CANCEL button on the remote control.
Off . . . Disables Auto Keystone.
Note:
•While Input search is set to On1 or On2, the status of Input and Lamp are displayed every time the signal is switched. •Only the last selected input source can be detected.
•If the INPUT button on the top control or the HDMI, COMPUTER, VIDEO or NETWORK buttons on the remote control is pressed during Input search is in progress, Input search will stop and go back to the previous input signal.
•Input search, Auto PC adj. and Auto Keystone cannot be set Off at the same time.
Auto setup
HDMI setup |
|
Terminal | Computer 2 |
Pointer | Dot |
Standby mode | Eco |
Note:
•Auto Keystone corrects vertical distortion only, not correct horizontal distortion.
•The Auto Keystone function cannot work when the Ceiling feature is set On in the Setting menu (p.53).
•Perfect correction of the image distortion cannot be ensured with the Auto setup function. If the distortion is not corrected properly by pressing the AUTO SETUP/CANCEL button, adjust manually by pressing the KEYSTONE button on the remote control or selecting Keystone in the Setting menu (pp.26,49).
•Fine sync, Total dots, Horizontal and Vertical position of some computers cannot be fully adjusted with the Auto PC adjustment function. When the image is not provided properly with this operation, manual adjustments are required
48
