Eiki LC-XB42N owner manual Setting, Power management, Time left before Lamp is off

Setting

Standby mode

This function is available when operating the projector via network.

Normal........ Supply the power to the network function even

after turning off the projector. You can turn on/ off the projector via network, modify network environment, and receive an e-mail about projector status while the projector is powered off.

Eco............. Select “Eco” when you do not use the projector

via network. The projector’s network function will stop when turning off the projector.

Refer to the owner’s manual “Network Set-up and Operation”.

Note:

•When selecting Normal, the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.

If the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with “No signal” appears. It starts the countdown until the lamp is turned off. Use the Point ◄► buttons to set the countdown timer.

Select one of the following options:

Ready	When the lamp has been fully cooled down,
	the POWER indicator changes to green
	blinking. In this condition, the projection
	lamp will be turned on if the input signal
	is reconnected or any button on the top
	control or remote control is pressed.
Shut down	When the lamp has been fully cooled down,
	the power will be turned off.
Off	Power management function is off.

Note:

• Factory default is "Ready: 5 min.".

Power management

Time left before Lamp is off.

Press the SELECT button at Power management and this dialog box appears. Use the Point ◄► buttons to choose one of the three options. Press the Point ▼ button to select the timer, and then use the Point ◄► buttons to set timer.

52