32 Chapter 4 SelfCalibration
Chapter 4 SelfCalibration
This product is equipped with an built-in calibrat ion sensor. This function allows you to set the calibration
targets or schedule in advance, and automatically execute reg ular calibration. Calibration can be executed
independently by the monitor.
Attention
• To execute SelfCalibrat ion, it is necessary to set the calib ration targets etc.
• For more informat ion, refer to “4-3. Setting Calibration Detail s [Setting]” (page 33).
NOTE
• Use SelfCalibr ation as support for monitor calibr ation with ColorNavigator.
• When mat ching the measurement result s of the built-in sensor with the measu rement results from a measur ement
device, use the Correlation Utility i ncluded with ColorNavigator. Refer to the ColorNavigator User's Manual on
the CD-ROM.
• SelfCalib ration can also be executed when there a re no computer signals being input.

4-1. Executing SelfCalibration [Calibration]

Procedure
1. Press .
The SelfCalibration menu appears.
2. Choose <Calibrat ion> from the SelfCalibration menu, and press .
3. Select “Execute” with or .
4. Press .
The built-in sensor is activated, and SelfCalibrat ion is executed.
Attention
• To execute SelfCalibrat ion, it is necessary to select CAL mode.
• After s electing execute, aging may be executed before t he built-in sensor is activated.

4-2. Checking Calibration Results [Result]

The previous calibration results can be checked.
Procedure
1. Choose <Result> f rom the SelfCalibration menu, and press .
2. Select the mode you want to check the resu lts for with or .
The Result menu appears.
The date and time the last SelfCalibration was execut ed, and the total monitor usage time from the
previous calibration are displayed.
3. Select “Calibration Result ” or “Ambient Light” with or .
The previous calibration results are displayed.
Attention
• The measu rement results of the ambient light sensor a re used to check the difference bet ween the current
environmental light level and the level of ambient light when cal ibration was executed, and are not ree cted in the
calibration results.
NOTE
• If <Ambient Light> i s selected, the current envi ronmental light is also displayed.
• Numerical v alues that do not reach the target values a re displayed in yellow.
• If the envi ronment in which the product is used is sig nicantly different to the prev ious environment, the ambient
light measurement results may dif fer greatly between the previous cal ibrations and current cal ibrations.