29
Chapter 3 Setting Monitor
3-5. Setting Language [Language]
This function allows you to select a language for the adjustment menu or d isplaying message.

Selectable languages

English/German/French/Span ish/Italian/Swedish/Japanese /Simplied Ch inese/Traditional Chinese
Procedure
1. Choose <Menu Setting s> menu from the Adjustment menu, and press .
2. Choose <Langu age> from the <Menu Settings> menu, and press .
3. Choose a langu age with or .
4. Press to exit the adjustment.
3-6. Setting Range of Frequency [Signal Bandwidth]
Depending upon your operating environ ment, it may be necessary to set the frequency t hat corresponds
to your graphics board. If you install it for the rst ti me or change environment, set the monitor.
NOTE
• Refer to the manu al of the graphics board.
• These envi ronment described below can be set reg ardless of whether or not the computer is r unning.
• Only digit al input signals can be set up.
Procedure
1. Press to tu rn off the monitor.
2. Press holding down at least 2 seconds to turn on the monitor.
The Optional Settings menu appea rs.
3. Choose <Signal Baldwidth> f rom the <Optional Settings> menu, and pre ss .
4. Select “Normal” or “Wide” wit h or , and press .
Use or to select (or just conrm) the frequency that corresponds to your gr aphics board.
Setting Horizontal scanning freque ncy
(kHz)
Vertical scanning frequency
(Hz)
Normal 26~78 59~61
Wide -1 26~78 23.75~63
Wide -2/-3 *1Used when inputting a special signal.
*1: Wide-2/3 cannot be selected when using D isplayPort.
5. Press
6. Select “Finish” with or .
7. Press .
The Optional Settings menu is closed.