
Power Wash 250™
The lamp orientation and optimization must be adjusted after every lamp change. This procedure centers the lamp in the reflector. Proper optimization will increase lamp life and ensure a bright crisp output. Improper optimization may add a yellow tint to the lamp output and reduce intensity. The minimum deviation amount is 1.0mm. Running the fixture within a lower deviation can cause damage to the lamp and/or lens.
The POWER WASH 250B™ lamp holder is aligned at the factory. However, due to slight imperfections in all lamps, fine adjustments may improve light performance. Please follow this procedure:
6.3.1Strike the lamp (for example in the LAMP menu) and wait a while until full intensity of the lamp.
6.3.2Using either a DMX controller or the control panel on the unit, strike the lamp and focus the light on a flat surface.(beam open, white, no gobo, no effects).
6.3.3Center the
6.3.4To reduce a
6.3.5If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back in the reflector. “Push” the lamp out by turning the screws
Attention: Be sure that the minimum distance between the lamp and lens is more then 1.0mm. If it is less then this distance, the lens has higher probability of shattering.
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com | - | Page 31 |