Elation Professional 250B user manual Adjust the DMX- Address D001, The Test Program TEST

Power Wash 250™

3.1Adjust the DMX- Address (D001)

After applying power to the POWER WASH 250B™ the LED will display the fixture’s current DMX address. If the fixture is not receiving a DMX signal the display will flash continuously.

D001

To set or adjust a DMX address, please follow the procedure below:

1.Switch on the POWER WASH 250B™ and wait for the fixture reset process to finished ('RESE' will flash in the LED while fixture is in reset mode).

2.Press the Mode button to access the main menu. Toggle through the menu by pressing the Up and Down buttons until the display shows D001. Tap the enter button to make changes to the address, the current three digit address will immediately begin to flash.

3.While the current three-digit address is flashing, use the Up and Down buttons to select adjust the address. Lock your new address into by pressing the Enter button. After the new address has been successfully stored into the fixture’s memory the LED will briefly readout OK.

The DMX address is non-destructible and will remain in the fixture’s memory even when the power has been switched off. Memory is backed-up and retained by an internal power source with a five year shelf life.

3.2The Test Program (TEST)

Test

The Test Program launched the fixture’s internal test mode. This function runs a complete test procedure of all functions. Press Enter to launch the self-test or the Mode button to cancel.

3.3The Audio Program (AUDI

The Audio menu allows you to run a stand-alone audio program. This program can run either fast (AFST) or slow (Aslw); Fast (AFST): When running in “fast” mode every sound impulse will trigger a new step. (Aslw): When running in You may run several fixtures together at once to achieve a synchronized light show running to sound in a Master/Slave configuration. To run in a Master/Slave.

©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 18