Elation Professional 05 FOCUS SPOT 250R, 28, Rev 10 manual Focus Spot 250R

Focus Spot 250R™

2.Tap the UP button until “EDIT” is displayed and press ENTER.

3.The display will show “SC - 01” , this stands for the scene number. For example, “SC-01” is displayed, it means you will be editing scene 1, press ENTER. You can change the scene number by tapping the UP button.

4.Press ENTER, the display will show “C-01,” this represents the channel number. If “C-01”is displayed, you will be editing the fixture’s channel 1 value of the selected scene, press ENTER. You can change the channel number by tapping the UP button.

5.The display will show the DMX value for the channel that is being edited. It will be displayed as “11XX,” it stands for Channel 11 of the editing scene, the DMX value is “XX.”

6.Adjust the DMX value by tapping the UP button, until you get the expected effect for this channel.

7.Press ENTER to enter the editing of the other channels of the scene.

8.Repeat steps 5-8, until you finish setting all the DMX values for all the channels of this scene, each scene can have 15 channels maximum.

9.Once all the channels are completed, the display will begin to flash “TIME,” this indicates the time needed to run this scene.

10.Press ENTER to edit the time needed, the display shows “T-XX”, “XX” stands for the time needed to run this scene. For example, “T-02”means scene 1 needs 6 seconds to run, “T-15”means this scene needs 45 seconds to run. Note: “XX” is always three seconds not one second.

11.Adjust the time needed by tapping the UP button.

12.Press ENTER to save the settings for the scene you are editing, the display will change to the next scene automatically.

13.Repeat steps 3-12 to edit other scenes, you can edit and save 48 scenes maximum.

14.Press MODE/ESC to exit and save your edited scene into the fixtures internal memory. The number of steps can be defined under “EDIT” and the scenes can be called up under “Run.” To run the scenes see page 30.

Editing procedure 2: Using an external controller.

1.Call up the first scene in your controller now.

2.Select “SC01” by pressing [UP] or [DN].

©Elation Professional® 34 Focus Spot 250R™