Elation Professional Spot 250 manual Edit Menu, Rec

Design Spot 250™

7.The display will then read “xxxx”, were “xxxx” stands for the calibrate values.

8.Adjust the desired calibration value between –128 and 127 by pressing the UP and DOWN. As you scroll up and down through the calibration values you will notice slight changes in the wheel or motor you are attempting to calibrate.

9.Once you reach your desired calibration press ENTER to confirm and lock in your calibration.

14.EDIT MENU

- T his menu item allows you to write a program into the fixture’s internal memory (EEPROM) via the control panel or via an external DMX controller.

STEP (S-01 - S-48) - These are the steps slots that you write your programs into. There are at total of 48 steps.

STXX (SC01 – SC48) - These are the scenes that are stored in your program. There are a total of 48 scenes. C-01 - C-11 (Channel 1 - Channel 11) – Represents the total fixture channels for each scene that can be edited.

TIME (Time) - Running time of the entire program. CEDT - Edit program using a external controller. REC – Auto save function.

RUN – Program test mode.

REC

-Records scenes automatically from any external DMX controller and stores them inside the fixtures built-in memory. These scenes can then be recalled without the use of an external controller.

1. Access the main menu.

2. Tap the UP or DOWN buttons until “EDIT” is displayed, then press ENTER.

3. Tap the UP or DOWN buttons until “REC” is displayed, then press ENTER.

4. After entering the REC function the display will read “RE.XX,” where as “XX” represents the scene number in the internal memory to which the scene will be stored.

5. Press the UP or DOWN buttons to select the desired scene number.

6. When you reach the scene number you wish to store the scene to, press

©Elation Professional® 36 Design Spot 250™