Installation
For proper operation, all directions regarding installation and connection must be followed.
Mounting
The DC-One should be mounted in a rack-mount enclosure or rack rails. The unit is 1RU tall by 14” (353mm) deep. Proper clearance for air circulation around the unit must be provided. Do not block any vent holes on the unit. For secure mounting and electrical insulation, correct rack screws must be used – #10-32 screw with plastic / nylon cup washer. All four mounting points provided by the rack ears must be secured.
Power Connection
The DC-One must be connected to A.C. power only by means of the provided IEC A.C. cable or by a power cable provided by the dealer / installer to match the configuration of your country or region. The DC-One must only be connected to a properly wired, three pin, grounded A.C. outlet. A.C. power must range from 100 – 240VAC, 50 – 60Hz. The DC-One internal power supply is an auto-ranging design; no adjustments are necessary to configure it for proper A.C. power.
Audio Cables
Always use correctly shielded audio cables when connecting to the DC-One.
Balance Input / Output Connections
To minimize induced noise caused by audio cables and to maximize the length of cables used, balanced connections are strongly advised for both Inputs and Outputs. The XLR jacks provided on the DC-One are configured as pin 1 ground, pin 2 hot (+), pin 3 cold (-). Cable shielding must be connected to pin 1. XLR – XLR cables or ¼” tip-ring-sleeve – XLR cables can both be used for balanced connections to the DC-One.
