Channel Level (Output Channels)
The Channel Level is used to adjust master output levels. To access the Channel Level
screen, press the Level button found on the output processing menu. Subsequent button presses will toggle the display between OUT1 to OUT6. Use the <SELECT> button to navigate between the selectable Level parameters
+6.0dB). Adjust the value by using the up/down VALUE arrows.
Channel Limiter (Output Channels)
20
10
Output 0 Level
|
|
|
| presented with |
|
dB | LIMITER |
|
| the Limiter |
|
Threshold = 0dB |
|
| screen. Use the |
| |
|
|
|
| ||
|
|
|
|
| |
|
|
|
| < SELECT> |
|
|
|
|
| key to navigate |
|
|
|
|
| between |
|
|
|
|
| Threshold |
|
|
|
|
| dBu to + 21.0 | Select Setup to switch Limiter Units from |
|
|
|
| dBu), Release | |
|
|
|
| dBu to Volts. | |
|
|
|
| (50.0ms to | |
|
|
|
|
| |
|
|
|
| 300.0 ms), Amp |
|
|
|
|
| (preset values for specific power amplifiers) and | |
| 0 | 10 | 20 | dB Bypass (on/off). Adjust the values of each | |
| parameter using the up/down VALUE arrows. | ||||
|
|
|
|
Limiter threshold values are determined by the amplifiers and loudspeakers that are used in the system. One important consideration in setting the limiter threshold value is the input sensitivity and gain of the connected amplifiers. Because different amplifiers can have different sensitivities, it is common to need to calculate the limiter offset to a factory preset based on the amplifier sensitivity. The
Amp Type
Q44, Q66,
CP1200,
CP1800,
CP2200,
CP3000S,
CP4000S,
32