Electro-Voice Speaker System owner manual Standard Edit Mode, Full Edit Mode, Parameters

HPF

Edit

Both Factory and User preset can be edited, but edited presets can only be stored in User preset locations.

Standard Edit Mode

The DC-One defaults to Standard Edit mode wherein, input and output channel parameters are appropriately linked. (Refer to “Configurations” illustrations to see which channels are parameter-linked for each configuration.

Linked parameters are always identical in value. For instance, setting a graphic eq curve for Input A, sets the same curve for Input B, if the configuration has linked stereo inputs. Either input channel can be edited; changes will be reflected in both. The same is true for parameters of linked output channels. The only exception to the linking of parameters is the Mute buttons. Output channels can be individually muted at any time, either from the DC-One front panel or the Graphic User Interface application.

Full Edit Mode

In the Setup menu, the edit mode can be changed to Full Edit. In Full Edit, no parameter links are enforced, regardless of the configuration selected. Any parameter can be changed without any effect on other parameter values.

Regardless of the edit mode selected, there are two means to enter edit mode: pressing the Edit button or pressing any DSP block button.

PROCESSING MENUS

PEQ GEQ Delay

INPUT

OUTPUT

Use the < Select > buttons to navigate to the top	X-Over PEQ Delay Level
line of any edit screen, and the Value Up and	( Repeat press for next channel )
Down buttons to navigate to any other Edit

screen. As a short-cut, press a DSP block button to jump to the last selected screen of said block and navigate as above to reach the desired screen.

Parameters

The following section is a detailed description of every DSP parameter available in the DC-One; grouped by DSP block, in order of the signal flow of the DC-One.

Input A&B DSP Block

Output 1-6 DSP Block

Not all parameters may be accessible in every preset and, depending on the configurations set by the contractor/installer, not all presets and/or preset values may be available for editing. Changes to preset availability, parameter availability and preset value ranges can only be set using the DC-One Editor PC application.

23 Owners Manual