Switching off the dishwasher
If the acoustic signal has been enabled, a continuous tone will sound for approx. 15 seconds at the end of the dishwashing cycle.
1 Carefully open the door. Hot steam may escape.
Hot dishes are sensitive to knocks. Therefore leave the dishes to cool for about 15 minutes before removing them. You also get a better drying result.
1.Press the ON/OFF button. All display indicators will go out.
2.Turn off the water tap.
3 If the dishwasher is not switched off, then the acoustic signal is repeat- ed after 3 minutes and after 6 minutes.
Removing the Dishes
3 It is normal for the inner door and the dispensers to be damp.
•Empty the lower basket first, then the upper basket. This way you avoid dripping water from the upper basket onto dishes in the lower basket.
Care and cleaning
1 Do not use furniture care products or aggressive cleaners.
•When necessary, clean the dishwasher’s controls with a soft cloth.
•Occasionally check the internal dispensers, door seal and water inlet filter (if fitted) for dirt and clean them, if necessary.
Polished chromium steel surfaces
Remove light dirt with a clean, damp, soft cloth – microfibre cloths are particularly good.
1 When cleaning ensure that you do not go against the direction of the stainless steel finish (the fine horizontal lines).
No circular movements!
Alulook surfaces
Remove light dirt with a clean, damp, soft cloth – microfibre cloths are particularly good.
Agents that scratch or scour are not suitable.
If required, use a commercially available cleaner for chrome surfaces. Follow the manufacturer’s instructions when using this cleaner.
23
