Electrolux E48DF76EPS, E30DF74EPS, E36DF76EPS manual Solutions to Common Problems, Possible Cause

42Solutions to Common Problems

PROBLEM	POSSIBLE CAUSE	SOLUTION
Nothing works.	Oven is not connected to electrical power	Have oven connected to a properly sized
		electrical power supply by a qualified technician.
	Power supply is not energized.	Have an electrician check power supply,
		including the house circuit breaker, wiring and
		fuses.
Oven will not heat.	Oven settings are not correct.	Follow mode selection and temperature
		settings as specified in OVEN OPERATION.
Foods overcooked.	Incorrect cooking time, temperature.	Adjust time, temperature or rack position.
Oven does not Self-Clean.	Door is not closed tightly, so the automatic door	Close door tightly.
	latch will not lock.
	Oven control knob set incorrectly.	Follow mode selection and temperature settings
		specified for SELF-CLEAN.
Oven light will not work.	Light bulb is burned out.	Follow REPLACING THE OVEN LIGHT.
Door will not open.	Oven is in Self-Clean mode.	If oven is hot, door latch will release
		automatically when oven temperqature falls
		below 490°F at end of cycle.
Oven will not heat after Self-Clean.	Oven settings not correct.	Follow mode selection and temperature settings
		as specified in OVEN OPERATION
Igniters do not spark.	Circuit breaker is tripped.	Reset circuit breaker
	House fuse is blown.	Replace house fuse.
	Power outage in local area.	Contact power company.
Sparking but no flame ignition	Gas shut-off valve is in the "off" position.	Turn shut-off to "on" position.
	Gas supply is interrupted.	Contact gas company.
Burners ignite but flame is extremely	Burner ring ports are clogged.	Clean burner ring ports with straightened paper
large, distorted or yellow.		clip, needle or wire.
	Burner ports or burner caps are not positioned	Remove and carefully re-install burner rings and
	properly.	caps.
	Cooktop is being operated on the wrong type	Ensure that the type of cooktop matches the gas
	of gas.	supply (natural gas or L.P. gas)
	Regulator is not installed, is faulty or is set for	Check installation, replace regullator, or set
	the wrong type of gas.	regulator for proper gas.
Burner flame goes out at low setting.	Low gas supply pressure.	Contact gas company.
Ignitors spark continuously after flame	Power supply is not grounded.	Have power supply properly grounded.
ignition.
	Power supply polarity is reversed.	Have polarity corrected.
	Ignitors are wet or dirty.	Dry or clean ignitors.