Electrolux E30DF74EPS, E48DF76EPS, E36DF76EPS Care & Cleaning, Starting The Oven Self-Clean Cycle

34Care & Cleaning

STARTING THE OVEN SELF-CLEAN CYCLE

The selector knob controls the Self-Cleaning feature. If you are planning to use the oven immediately after a self-clean cycle remember to allow time for the oven to cool down and the oven door to unlock. This normally takes about one hour.

A 3-hour self-clean cycle will actually take about 4 hours to complete.

WARNING

During the Self-Cleaning cycle, the outside of the appliance can become very hot to the touch. DO NOT leave small children unattended near the appliance; they may be burned if they touch the hot oven door surfaces.

WARNING

DO NOT force the oven door open. This can damage the automatic door locking system. Use care when opening the oven door after the self-cleaning cycle. Stand to the side of the oven when opening the door to allow hot air or steam to escape. The oven may still be VERY HOT.

To start a Self-Cleaning cycle:

1.Be sure oven is empty and the oven door is closed.

2.Turn selector knob to Self Clean.

3.The corresponding LED will flash.

4.Turn temperature knob to Clean.

5.The LED for “Lock” will flash while transitioning from unlock to lock. It will stop flashing when the door is locked.

NOTE

If the “- Racks” LED is flashing when the clean mode is initiated, the oven racks and rack glides with supports have not been removed. It will discontinue flashing, once the selector knob is set back to the off position and the racks and rack glides with supports are removed from the oven (not applicable to model E48DF76EPS companion oven).

6.As soon as the controls are set to clean, the motor driven oven door lock will begin to close automatically. Once the door has been locked the indicator light will stop flashing and remain on. Allow about 30 seconds for the oven door lock to close.