Electrolux EOB 53003 Instructions for the Installer, Electrical connection, Terminal block

Instructions for the Installer

The instructions given below are designed specifically for a qualified installer and should aid him or her to perform all installation, adjustment, and maintenance operations with absolute precision and in compliance with all current legislation and regulations. We strongly recommend that all operations for the installation of your appliance be carried out by Qualified Personnel in accordance with existing rules and regulations.

Electrical connection

Prior to making the electrical connection, make sure that:

—the protection fuse and the domestic wiring system are suitable to carry the total electric load of the oven (see rating plate);

—your domestic wiring system has an efficient earth connection in compliance with rules and laws in force;

—the wall socket or the omnipole switch used for the electrical connection can easily be reached after the oven is built in.

This appliance is supplied with a connection cable incorporating a standard plug, suitable for the total electric load shown on the rating plate. The plug is to be inserted into a suitable wall socket. If you require a direct connection to the electric network (mains), it will be necessary to fit between the appliance and the mains an omnipole switch, with a minimum gap between contacts of 3 mm, suitable for the required load and in compliance with rules in force. The green & yellow ground wire must not be interrupted

by the switch and it should be 2-3 cm. longer than the other cables. The supply cable must in all cases be laid out in such a way as to ensure that it does not reach at any given point a temperature 50°C higher than the ambient temperature.

Suitable power supply cables are the following types, considering the respective necessary section of cable: H07 RN-F, H05 RN-F, H05 RR-F, H05 VV-F, H05 V2V2-F (T90), H05 BB-F.

Terminal block

The oven has an easily accessible terminal block, which is meant to work with an electric single-phase rate of 230 V (Fig. 16).

The Manufacturer disclaims any liability in case these accident-preventing rules are not observed.

Fig. 16

electrolux 53