INSTALLATION Solid Pipe Installation
FITTING THE APPLIANCE AND CABINET.
1Make suitable arrangements for gas and electrical supplies into the installation site. Preferably a junction box or a 3 pin earthed socket should be situated at the back of the cabinet below the oven.
2Fit cabinet as Fig. 1, making sure that it is level.
3When unpacking the appliance keep it on it's polystyrene base until it is put into the cabinet to avoid damage.
NOTE: It is imperative that the appliance is left in the base to protect both the appliance and the floor. Do not allow young children to play with any part of the packaging.
4 | Solid gas pipe installation: | GAS INLET SUPPLY BLOCK | ||||
|
|
| ||||
| i) | Remove the fascia control panel (See section A |
|
|
| |
|
| on page 39). |
|
|
|
|
| ii) Slacken and remove the union nut on the gas |
|
|
| ||
|
| supply elbow on the right hand side of the |
|
|
| |
|
| control panel. See Fig.7. |
|
|
| |
| iii) Remove the two screws on the gas inlet block |
|
|
| ||
|
| Fig.3. |
|
|
|
|
|
|
|
|
| 680 | |
| iv) | Withdraw the gas inlet block and pipe assembly |
|
| ||
|
| from the back of the appliance |
|
| ||
|
|
|
|
| ||
|
|
|
|
| ||
| v) | Remove the union elbow from the inlet block |
|
|
| |
|
| and pipe assembly. The elbow will be required |
|
|
| |
|
| in the final installation. |
|
|
| |
| vi) | The union | elbow should be connected to the |
|
|
|
|
| gas supply pipe via a standard ¼"B.S.P. straight | 120 |
| ||
|
| connector. |
|
| ||
5 Install the gas supply pipe on site complete with the |
| Fig.3 | ||||
| union elbow (See Fig.4). Note the orientation of the |
| ||||
|
|
|
| |||
| elbow, the connection must be upwards. | 120 |
| |||
6 | Position the appliance in front of the cabinet and run |
| ||||
|
|
| ||||
the supply cable (See Section 2) through the cabinet and connect to the junction box or socket. Ensure that the supply is isolated at this stage.
N.B. Two people will be required to carry out the lifting procedure.
Warning: Do not attempt to lift this appliance by the handles.
7Lift the appliance into the cabinet making sure the gas supply pipe enters the duct in the rear of the appliance and the cable is not trapped by the appliance. Push the appliance as far back as it will go. Ensure the supply pipe comes through the control panel and pull through any slack cable.
8Centralise and fix the appliance to the cabinet using six wood screws in the position indicated in Fig.2.
9Tighten the union nut into the supply elbow.
10Carry out a gas tightness test after connecting to the gas supply. NOTE: Check supply pressure before fitting fascia (See Section 3).
SIDE VIEW | FRONT VIEW |
75 |
|
225 | |
| mm |
Fig.4
795
37
