
Care and cleaning
E O G 6 6 0
4Using both hands, gently tilt the top of the door glass towards you. Lift slightly to disengage the locators at the bottom of the door.
5Clean the outer and inner glass using hot soapy water and mild abrasives such as 'Jif'.
6Replace the glass by holding it in both hands and gently placing the locators into the holes of the brackets at the bottom of the door. Push the top of the glass towards the oven door, and make sure the screw location holes line up. Replace the trim on top of the door making sure that it is correctly positioned. You can check this by looking through the air gap on the top of the door and checking that the screw location holes line up.
7Hold the glass in place with one hand and replace the cross head screws into the location holes, with the other hand.
8Tighten the screws using a pozidrive screwdriver. Close the door.
Cleaning The Door Glass
To prevent damaging or weakening the door glass panels avoid the use of the following:
Household detergents and bleaches
Impregnated pads unsuitable for
Brillo/Ajax pads or steel wool pads
Chemical oven pads or aerosols
Rust removers
Bath/Sink stain removers
If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Please contact your local Service Centre who will be pleased to advise further.
30