|
|
|
|
Something Not Working | GB |
| |
Before contacting your local Service Force Centre check the following point: |
|
| |
|
|
| |
Problem | Possible cause / Remedy |
| |
|
|
| |
"" is displayed in the temperature | Please contact your local Electrolux Service Force Centre |
| |
display. |
|
|
|
|
|
| |
Audible alarm + flashing red warning | Switch off the audible alarm by pressing the alarm off button. |
| |
lamp. (It is too warm inside the freezer.) | The audible alarm could have been triggered by: |
|
|
| The cabinet having been recently switched on and the |
| |
| temperature still being too high. See the chapter | "Switching on |
|
| and setting the temperature". |
|
|
| The door may have been open for so long that the `door open' |
| |
| alarm was triggered. |
|
|
|
|
|
|
It is too warm inside the freezer. | Set a lower temperature. |
|
|
| Make sure that the door is completely closed and that the |
| |
| insulating strip is complete and clean. |
|
|
| If warm food products have been put inside the freezer, wait for |
| |
| a couple of hours and then check the temperature again. |
| |
| Distribute the food products to allow cold air to circulate |
| |
| around them. |
|
|
|
|
|
|
It is too cold inside the freezer. | Set a warmer temperature. |
|
|
| Fast Freeze could have been switched on. |
|
|
| The temperature display shows the highest temperature inside |
| |
| the cabinet. Thus a difference between the temperature |
| |
| indicated on the display and the (average) temperature |
| |
| measured in another way is normal. |
|
|
|
|
| |
Too much frost and ice are produced. | Make sure that the door is completely closed and that the |
| |
| insulating strip is complete and clean. |
|
|
|
|
|
|
The compressor operates continuously. | Set a warmer temperature. |
|
|
| Make sure that the door is completely closed and that the |
| |
| insulating strip is complete and clean. |
|
|
| The temperature where the cabinet is placed is above normal |
| |
| room temperature. |
|
|
|
|
| |
No ice | The ice machine is not switched on. Start the ice machine. See |
| |
| the section "Switching the ice machine on and off". |
| |
| No water supply. Carry out the necessary measures on the |
| |
| water supply. |
|
|
|
|
| |
The ice dispenser lamp flashes | Leakage at the water connection. Remedy the leakage and |
| |
| empty the box by pulling out the red plug. |
|
|
| See the illustration in "Connecting the water hose". |
| |
| Storage temperature too high. Lower the temperature in the |
| |
| refrigerator. |
|
|
|
|
| |
The ice dispenser lamp flashes and no ice | No water supply. Carry out the necessary measures on the |
| |
comes out. | water supply. |
|
|
|
|
| |
Electrolux 818 38
11
