Emerson AV301 owner manual Bass Mode Setting

Bass Mode Setting

Path: Main Page	Speaker Setup Page	Bass Mode	The default setting is CONFIGURATION 1 because your
			system was supplied with Speaker Configuration 1, which
			means 5 compact size satellite speakers and one subwoofer.
			The CONFIGURATION 1 setting directs all of the bass sounds
			to the subwoofer only. While the Bass Mode is set to
			CONFIGURATION 1 the subwoofer cannot be switched off
			and the bass level of the front speakers cannot be adjusted.

CONFIG 1

CONFIG 2

Front-left (Included)

In the future if you decide to replace the compact front left and right satellite speakers with larger full range speakers that can also produce deep bass sounds, you can change the Bass Mode default setting to CONFIGURATION 2. This will allow you to switch the subwoofer 'off' and will also allow you to adjust the bass level of the front speakers.

(See "Adjusting the Volume and Tone Controls" on page 39)

Center (Included)	Front-right
	(Included)

Subwoofer (Included)

Surround-left	Surround-right
(Included)	(Included)

LISTENING

POSITION

CONFIGURATION 1 must be selected when using the 5 satellites and subwoofer which were included with your system.

Surround-left (Included)

	Center (Included)
Front-left		Front-right
(sold separately)		(sold separately)

Subwoofer

(Included)

LISTENING

POSITION

Surround-right (Included)

CONFIGURATION 2 should only be selected if the left and right front satellites are replaced by larger full range left and right front speakers.

34